Ninja 500/SE(2024)Puig license plate holder

License Plate Holder for motorcycle KAWASAKI NINJA 500 SE 2024

Replace the original license plate holder of your motorcycle with Puig's license plate holder, which thanks to its elevated position gives your motorcycle a sporty look. The set combines steel parts with epoxy paint finish and polyamide parts, achieving a significant weight reduction compared to the original holder.

 

Some license plate holders have the option of being fixed or adjustable depending on the reference that fits each motorcycle. They include supports for turn signals, but it is important to note that they are not compatible with the original turn signals, which can be adjusted horizontally up to 3 cm.

 

The assembly of the piece is very simple and comes with instructions.

 

It is important to mention that the holder does not include turn signals; these must be purchased separately. In addition, connectors for the license plate light are not included.

 

FIXED OR ADJUSTABLE IN TILT

NOT COMPATIBLE WITH SIDE CASES

The license plate part number does not include the extension of the lighting group wiring. See if the part number below is available on accessories.

 

Brake rear light not included

Adjustable turn light support

Includes Kit (license support light + relocation brackets + homologated reflector)

 

PAIR OF SUPPORT FOR ORIGINAL TURN LIGHT

Check the measurements of the holes once the turn signal has been removed to determine the part number to choose.

 

Essential if you would like to maintain the original turn signal of your motorbike when assembling our license holder

9320N

HKD 130

 

EXTENSION LICENSE PLATE HOLDER LIGHTING GROUP

Wiring with connector OEM

Cable length: 300mm

3850N

HKD 70

 

Rear Turn Signals Extension

Wiring with connector OEM

Cable length: 300mm

4856N

HKD 80